Panasonic TGP600: Light Codes
The following table will instruct you on the light codes for the TGP600 device.
Light |
Status |
Description & Suggested Action (Likely Failures in Bold) |
| STATUS | Green (Solid) | The Base Unit is connected to the Internet. The startup process is complete and you may now make Internet calls. |
| Green (Flashing) | The base unit is downloading data. Do not disconnect the Ethernet cable or AC adaptor for the base unit until the STATUS indicator stops flashing and lights in steady green. | |
| Red (Solid) | When the Base Unit is turned on, the STATUS indicator lights in red for about 10 seconds. | |
| Red (Flashing) | The Base Unit is registering a handset. | |
| Red (Rapidly Flashing) | The Base Unit is paging handsets. (KX-TGP-500 only) | |
| Amber (Solid) | The Base Unit's IP address may conflict with the IP addresses of other devices on your local network. Contact your Administrator for further information. | |
| Amber (Flashing) | The Base Unit is obtaining an IP address or is obtaining configurations. // Please wait. | |
| The Base Unit is registering with your phone system. // Please wait. | ||
| If the STATUS indicator continues to flash check the following: - Network settings may not be correct. // Contact your Administrator. - Many installation issues can be resolved by resetting all the equipment. // First, shut down your Modem, Router, Hub, Base Unit & Computer. - If you cannot access Internet web pages using your Computer, check to see if your phone system is having connection issues in your area. |
||
| Unlit | The Base Unit power is off. | |
| The Ethernet cable is not connected properly. // Connect it. | ||
| Your network devices (Hub, Router, etc.) are turned off. // Check the LEDs for the link status of the devices. | ||
| The Base Unit power is booting up. |